Readme 1st:

Wire EDM Control Screens:

This uses movement axis (X and A/U), and Y and B/V) it has a Slave and Unslave button
so you can operate it in 2 or 4 axis mode. You can have your Cam softwares post Processor send out the Slave and UnSlave OEM code so that it will auto slave and unslave for you depending on the type of cut you need.

The Wire Feed On/Off and wire feed rate are the spindle output, wire on is M3, m5 is off.

You will need to set up a PID loop in your PLC to handle your Wire current, AND you will need to
have your PID send a signal for feedrate reduction if your getting into the upper zones.
also, you will need to have a sensor input for Wire breaks.

Scott